Installation; General - Hatco FSHC-6W Série Manuel D'installation Et D'utilisation

English

General

Flav-R-Savor Portable Holding Cabinets are shipped with most
components installed and ready for operation. The following
installation instructions must be performed before plugging in
and operating the cabinet.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAzARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
Locate unit in an area that is convenient for use. The
location should be level to prevent unit or its contents from
falling accidentally and strong enough to support the
weight of the unit and contents.
1. Remove the unit from the carton.
2. Remove all loose items shipped inside the cabinet such as
the box containing the adjustable pan shelves, the
casters/legs, etc...
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
3. Remove tape and protective packaging from all surfaces of
the unit.
NOTE: If 4" (102 mm) leg or 6" (152 mm) leg installation is
required, refer to the OPTIONS aND aCCESSORIES
section in this manual for installation instructions.
Form No. FSHC67m-0714
CAUTION
Shelf
Support
Pin
Shelf
Support
Adjustable
Pan Shelf
4. Install the 4" (102 mm) casters onto the bottom of the cabinet.
a low profile caster option is available for the FSHC-6W
series—use the same procedure below to install.
Do not lay unit on side with control panel or damage to unit
could occur. Make sure all water is drained prior to laying
unit on its side.
a. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and the
floor to prevent marring the cabinet finish.
b Install the two swivel casters to the front of the unit using
four mounting screws (provided). Tighten securely.
c. Install the two stationary casters to the back of the unit
using four mounting screws (provided). Tighten securely.
d. Return the unit to its upright position. This step requires
two people.
5. Unpack the adjustable pan shelves from the box and install
them inside the cabinet. There are twelve or fourteen
adjustable pan shelves—half on each side of the cabinet.
Four shelf support pins, two on each side of the cabinet,
support the pan shelves.
To install each pan shelf:
a. align the adjustable pan shelf hooks with the desired
slots on the front and rear shelf supports.
b. Drop the adjustable shelf hooks on top of the desired
shelf support pin on each end of the shelf supports.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods, exterior doors,
and air conditioning ducts).
• make sure the unit is located on solid, level flooring.
• make sure the unit is at the proper height in an area
convenient for use.
Drop Adjustable Pan Shelf Hook
over the Shelf Support Pin
to secure Adjustable Pan Shelf.
4" Swivel Caster
Installing the Components
7

INSTALLATION

NOTICE
Mounting Screw