Installation; General - Hatco HWBI-S Serie Manuel D'installation Et D'utilisation

INSTALLATION

General

Slim Drop-In Heated Well units are shipped from the factory
with most components assembled and ready for use. Use the
following procedures to install the unit.
NOTE: All Slim Drop-In Heated Wells require the control
enclosure to be remote mounted.
WARNING
ELECTRIC SHOCK HAZARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as
well as damage to unit and/or its surroundings.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
FIRE HAZARD:
• Install unit with a minimum of 3-1/2" (89 mm) of space
from bottom of unit to all combustible surfaces to
prevent combustion.
• Unit must be installed using ribbon putty gasket
between unit and installation surface per installation
instructions (refer to INSTALLATION section of this
manual).
This unit must be installed by qualified, trained installers.
Installation must conform to all local electrical and
plumbing codes. Check with local plumbing and electrical
inspectors for proper procedures and codes.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. The location should be strong enough
to support the weight of unit and contents.
NOTICE
Units are voltage-specific. Refer to specification label for
electrical requirements before beginning installation.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to unit.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact the manufacturer of the
countertop material for application information.
1. Remove the unit from the box.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the IMPORTANT
OWNER INFORMATION section for details.
2. Remove tape and protective packaging from all surfaces
of unit.
NOTE: A qualified electrician should connect the unit(s) to a
power source. A qualified plumber should connect the
water supply and drain(s).
3. Install the unit in the desired location (refer to the "Installing
the Unit" procedure later in this section).
4. Install the remote control enclosure (refer to the "Installing a
Remote Control Enclosure" procedure later in this section).
Installing the Unit
NOTE: Cut the opening for both the unit and the control
enclosure(s) before placing unit into the countertop
opening.
1. Make sure the control enclosure installation location(s) is
within reach of the conduit assemblies that run beween the
unit and the control enclosure(s).
2. Cut the appropriate opening in the countertop.
Refer to the "Countertop Cutout Dimensions" chart in this
section.
3. Cut the appropriate opening for the control enclosure(s)
Refer to the "Control Enclosure Cutout Dimensions" chart
in this section.
4. Place ribbon putty gasket around the cutout edge of the
countertop. Make sure the ribbon putty gasket overhangs
the cutout edge or seal unit with silicone adhesive.
NOTE: A roll of ribbon putty gasket material is supplied with the
unit.
Countertop
Installing Ribbon Putty Gasket
5. Place the unit into the countertop opening.
8
English
Ribbon Putty
Gasket
Cutout edge
of countertop.
HWBISM-0722