Dispenser Returns A Failure Command (A2) - Nordson EFD Ultimus V Manuel Utilisateur

Doseur de Fluide Haute Précision Ultimus V
Annexe B — Protocole RS-232 (suite)
Troubleshooting Remote Communication (suite)
3.1 No Response from the Dispenser (continued)
6. Check that you are using the correct command format, as explained under "2.6.2 Write Commands" on
page 51 and "2.6.3 Read Commands" on page 63.
7. Check that you are sending the Enquiry (
single-byte text packet (hexadecimal
NOTE: This also applies to the
do not need STX

3.2 Dispenser Returns a Failure Command (A2)

1. Check that the length of the data and the checksum calculation is correct in the sent text packet. If the
checksum is incorrectly calculated, the dispenser discards the text packet and returns a Failure Command (
response.
2. If the client sends an Enquiry (
( ACK / 0x06 ) text packet. However, if the client does not transmit the next text packet within 2 seconds, the
dispenser enters a Communication Timeout and responds with a Failure Command (
To recover the communication, ensure that the length of the data and checksum calculation are correct, then
restart the communication by sending the Enquiry (
the correct write / read communication sequence as explained under "2.4.1 Write Text Packets" on page 46
and "2.4.2 Read Text Packets" on page 48.
76
www.nordsonefd.com/fr EFDEU-South@nordson.com
ENQ /
0x05 ), not as separate "E," "N," and "Q" characters.
ACK ( 0x06 ), NAK
( 0x02 ) or ETX ( 0x03 ) added to them.
ENQ / 0x05 ) text packet, the dispenser responds with an Acknowledgment
+33 (0) 1 30 82 68 69 Les services et les points de vente des systèmes de dosage Nordson EFD sont présents dans le monde entier.
0x05 ) control character from the client to the dispenser as a
( 0x21 ), EOT ( 0x04 ) control characters. Control characters
ENQ / 0x05 ) control character to the dispenser and following
A2 )
A2 ).