Read Commands; Pressure Time Read Command - Nordson EFD Ultimus V Manuel Utilisateur

Annexe B — Protocole RS-232 (suite)

2.6.3 Read Commands

For these commands, the client requests a set of data from the dispenser, which the dispenser will return before
ending the transmission. Read commands are sent using the sequence explained in "2.4.2 Read Text Packets" on
page 48.
NOTE: The two hyphens "--" shown in the commands represent ASCII space values (Hex 0x20).

2.6.3.1 Pressure Time Read Command

This command returns the Dispense Pressure and Dispense Time for the specified address. It also updates the LCD
screen to the specified memory location.
Client command and data: UCccc
ccc: The 3-digit memory location from 0–399. The dispenser will automatically limit value to prevent any errors.
EXAMPLE: To read the Dispense Pressure and Dispense Time values in memory location #1, the text packet is:
(STX) + 05 + UC001 + 72 + (ETX)
NOTE: This command changes the current memory location in the dispenser as set in the command (e.g., 001 in
above example command), in addition to returning the values for Dispense Pressure and Dispense Time.
The above text packet in hexadecimal format:
STX 0 5
0x02 0x30 0x35
NOTE: "D0" is the letter "D" followed by the digit "0."
Return Format: D0PDppppDTtttt
pppp: The 4-digit pressure setting excluding the decimal point. This is a unitless value. The valid pressure ranges
and decimal point are determined by the pressure units currently selected in the dispenser.
ttttt: The 4-digit dispense time value excluding the decimal point. The valid range is 0.000 to 9.999. This command
truncates the last decimal place of the dispense time. This was done to make this command compatible with
the Musashi FX808 protocol.
Interpreting the pressure setting from the return feedback value:
Value Received from the
Pressure Unit
Dispenser (pppp)
psi 0000–1000
kPa 0000–6895
Bar 0000–6895
EXAMPLE: If the pressure setting at the requested memory location is 50.0 psi and the time setting is 1.005 s, the
text packet received from the dispenser is: (STX) + 0E + D0PD0500DT1005 + 60 + (ETX)
Length of the response text packet: Decimal 14 or hexadecimal 0x0E
The above text packet in hexadecimal format:
STX 0 E
0x02 0x30 0x45
0 0 5
0x30 0x30 0x35
www.nordsonefd.com/fr EFDEU-South@nordson.com
U C 0 0
0x55 0x43 0x30 0x30
D 0 P D
0x44 0x30 0x50 0x44
6 0 ETX
0x36 0x30 0x03
+33 (0) 1 30 82 68 69 Les services et les points de vente des systèmes de dosage Nordson EFD sont présents dans le monde entier.
Doseur de Fluide Haute Précision Ultimus V
1 7 2
0x31 0x37 0x32 0x03
Pressure Setting
0.0–100.0 psi
0.0–689.5 kPa
0.000–6.895 bar
0 5 0
0x30 0x35 0x30 0x30
ETX
0 D T 1
0x44 0x54 0x31
63