Read Text Packets - Nordson EFD Ultimus V Manuel Utilisateur

Masquer les pouces Voir aussi pour Ultimus V:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Doseur de Fluide Haute Précision Ultimus V
Annexe B — Protocole RS-232 (suite)

2.4.2 Read Text Packets

When a Read text packet is sent, the dispenser sends the requested data back to the client.
NOTE: Refer to "Diagram of Write Text Packet Communication between the Client and Dispenser" on page 47 for
a visual representation of the Write command sequence.
The Read text packet sequence is as follows:
5.
The client transmits an Enquiry (
6.
When the dispenser receives the Enquiry (
(
ACK
 / 0x06) back to the client.
7.
When the client receives the acknowledgment (
2 seconds to avoid a communication timeout.
EXAMPLE:
(STX) + 04 + UA-- + C6 + (ETX)
[In this example, the hyphen (
NOTE: The plus signs (+) are present only to show how each character is appended to form the example text
packet; they are not part of the transmitted data. The parentheses are present only to indicate a single-byte
control character, and are also not part of the transmitted data.
The above text packet in hexadecimal format is shown below:
STX
0
0x02
0x30
8.
When the dispenser receives the text packet, the dispenser transmits a Success Command (A0) text packet to
the client.
EXAMPLE:
(STX) + 02 + A0 + 2D + (ETX)
In the above text packet, the Checksum is
NOTE: The plus signs (+) are present only to show how each character is appended to form the example text
packet; they are not part of the transmitted data. The parentheses are present only to indicate a single-byte
control character, and are also not part of the transmitted data.
The above text packet in hexadecimal format is shown below:
STX
0
0x02
0x30
If there is an error in the text packet, if it cannot be executed, or if the transmission was interrupted and timed
out (if the client takes more than 2 seconds to send a text packet), the dispenser transmits a Failure Command
(
A2
) text packet. Refer to "1.1 RS-232 Pin Assignments" on page 39 for details.
EXAMPLE:
(STX) + 02 + A2 + 2B + (ETX)
The above text packet in hexadecimal format is shown below:
STX
0
0x02
0x30
48
www.nordsonefd.com/fr EFDEU-South@nordson.com
ENQ
/
0x05
) to the dispenser.
ENQ
-
) represents an ASCII space value (Hex
4
U
A
space space
0x34
0x55
0x41
0x20
2D
. The Checksum calculation method is explained in 2.3.5.
2
A
0
2
0x32
0x41
0x30
0x32
2
A
2
2
0x32
0x41
0x32
0x32
+33 (0) 1 30 82 68 69 Les services et les points de vente des systèmes de dosage Nordson EFD sont présents dans le monde entier.
/
0x05
), the dispenser transmits an acknowledgment
ACK
/
0x06
), the client must send the Read text packet within
0x20
C
6
0x20
0x43
0x36
D
ETX
0x44
0x03
B
ETX
0x42
0x03
].
ETX
0x03

Publicité

Table des Matières
loading

Table des Matières