Rinse Aid Dispenser - GE GLD8000 Série Manuel Du Propriétaire

English

Rinse Aid Dispenser

Rinse aids prevent water from forming droplets that can dry as spots or streaks. They also
improve drying by allowing water to drain off the dishes during the final rinse by releasing
a small amount of the rinse aid into the rinse water. Your dishwasher is designed to use a
liquid rinse aid. Do not use a solid or bar-type.
Filling the Dispenser
The rinse aid dispenser holds 4.8 oz (145 mL) of rinse aid. Under normal conditions, this will
last for about three months. Rinse aid is released through an opening in the dispenser. You
do not need to wait until the dispenser is empty to refill it. Try to keep it full, but be careful
not to overfill it.
1. Make sure the dishwasher door is fully open.
2. Open the dispenser by pushing the cover latch.
3. Add rinse aid until the indicator window looks full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Close the cover.
Rinse Aid Setting
The amount of rinse aid released into the final wash can be adjusted. The factory setting is
at 3. For most water conditions, set the adjuster to 2 or 3. If there are rings of calcium
(hard water) spots on dishes, try a higher setting.
To Adjust the Setting
Open the dispenser cover. Turn the adjuster inside the dispenser to the desired setting.
15