Filling The Dispenser; Rinse Aid Setting - GE GLDT690 Série Mode D'emploi

Using the dishwasher
Check the Water Temperature
The entering water should be at least 120°F (49°C) and not
more than 140°F (60°C) for effective cleaning and to prevent
dish damage. Check the water temperature with a candy or
meat thermometer.
Use a Rinse Agent
Rinse agents, such as Cascade
spots and film build-up on your dishes, glasses, flatware, cookware, and plastic.

Filling the Dispenser

The rinse agent dispenser holds 3.5 oz. (104 ml) of rinse agent. Under normal
conditions, this will last approximately one month - depending on setting.
1
Make sure the dishwasher door is fully open.
2 Turn the dispenser cap to the left and lift it out.
3
Add rinse agent until the indicator window looks full.
4
Clean up any spilled rinse agent with a damp cloth to prevent foam from forming
inside the dishwasher.
Replace the dispenser cap.
5

Rinse Aid Setting

The amount of rinse agent released into the final wash can be adjusted. The factory setting is at
the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting (a higher
number indicates a higher dosage). If you observe foam in the final rinse, try a lower setting.
To adjust the setting
Remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount of rinse agent
or clockwise to reduce the amount of rinse agent dispensed.
6
Rinse Aid are designed for great drying action and to protect against
®
Turn on the hot water faucet nearest the dishwasher,
place the thermometer in a glass and let the water run
continuously into the glass until the temperature stops rising.
Indicator
Adjustable setting
Dispenser cap