Ryobi RY906500S Manuel D'utilisation page 11

SYMBOLS
FUEL WARNING
No smoking when filling with gasoline.
Do not overfill. Full level is 1 in. below
the top of the fuel neck. Stop the en-
gine for five minutes before refueling to
avoid the heat from the muffler igniting
fuel vapors.
CHECK LUBRICANT
ENGINE LUBRICANT WARNING
You must add lubricant before first
operating the generator. Always check
the lubricant level before each opera-
940708019-03
tion. The lubricant level should always
register between the hatched areas on
the dipstick. The unit is equipped with
a sensor which will automatically shut
off the engine if the lubricant level falls
below a safe limit.
GROUNDING WARNING
This generator does not include a ground
rod or copper wire. Call a qualified elec-
trician for local grounding requirements.
WARNING
HOT SURFACE AND EXHAUST
HOT SURFACE WARNING
AVERTISSEMENT
Do not touch the muffler or aluminum
SURFACE ET D'ECHAPPEMENT CHAUD
cylinder of the engine. They are very
ADVERTENCIA
HOT and will cause severe burns. Don't
put body parts or any flammable or
SUPERFICIE Y DE ESCAPE ESTEN CALIENTE
940680027-05
combustible materials in the direct path
of the exhaust.
CLEARANCE WARNING
While operating and storing, keep at
least 3 feet of clearance on all sides of
this product, including overhead. Allow a
minimum of 30 minutes of "cool down"
time before storage. Heat created by
muffler and exhaust gases could be hot
enough to cause serious burns and/or
ignite combustible objects.
SPARK ARRESTOR
Operation of this equipment may create
sparks that can start fires around dry
vegetation. A spark arrestor may be
required. The operator should contact
local fire agencies for laws or regulations
relating to fire prevention requirements.
FUEL CAP WARNING
Never remove fuel cap when unit is run-
ning. Shut off engine and allow the unit
to cool at least five minutes. Remove cap
slowly to release any pressure built up
in the fuel system and to avoid the heat
from the muffler igniting fuel vapors.
Page 7 — English