Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Press the input select button to select the
&
input signal.
Input select
buttons
Changing
signals
BA picture will be projected in accordance with the selected input
signal.
BWhen a YP
instead of "RGB".
B"NETWORK" is for PT-LB10NTU only.
Follow the procedure below when you set the projector up first, and when
you change the setup place.
Adjusting the angle
'
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector. Adjust so that the
projector is as vertical to the screen
as possible.
Press the AUTO SETUP button to initiate
(
automatic positioning.
BThe tilt of the projector and the input
signal will be detected and keystone
distortion and the position of the
image will be corrected.
(Refer to page 28 for details.)
Adjusting the size
)
BTurn the zoom ring to adjust the size of the projected image.
Adjusting the focus
*
BTurn the focus ring to adjust the focus of the projected image.
VIDEO
S-VIDEO
NETWORK
RGB
P
signal is being input, "YP
B
R
VIDEO
RGB
VIDEO
NETWORK
S-VIDEO
P
" will be displayed
B
R
AUTO SETUP
E
NGLISH
RGB
-25
Publicité
Table des Matières
