Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Press the input select button to select the
&
input signal.
Control
panel
Remote
control
unit
BA picture will be projected in accordance with the selected input
signal.
BWhen a YP
instead of "RGB".
B"NETWORK" is for PT-LB20NTU only.
Follow the procedure below when you set the projector up first, and when
you change the setup place.
Adjusting the angle
'
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector. Adjust so that the
projected image is placed at the
center of the screen.
Press the AUTO SETUP button to
(
initiate automatic positioning.
BThe tilt of the projector and the input
signal will be detected and keystone
distortion and the position of the image
will be corrected.
(Refer to page 28 for details.)
Adjusting the size
)
BTurn the zoom ring to adjust the size of the projected image.
*
Adjusting the focus
BTurn the focus ring to adjust the focus of the projected image.
Input select
button
Changing
signals
Input select
buttons
VIDEO
Changing
signals
S-VIDEO
P
signal is being input, "YP
B
R
RGB1
RGB2
S-VIDEO
VIDEO
RGB1
P
" will be displayed
B
R
NETWORK
VIDEO
RGB
RGB2
NETWORK
AUTO SETUP
E
NGLISH
-25
Publicité
Table des Matières
