Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Direct power off function
You can disconnect the power cord during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
B When this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the power cord
connected.
B Do not put the projector in a bag while the cooling fan is operating.
CAUTION
If not using the projector for an extended period of time, disconnect the
power cord plug from the wall outlet.
B If dust builds up on the power cord plug, the resulting humidity may
damage the insulation, which could result in fire.
B This projector continues to draw approximately 6 W of power even when
the power is turned off.
Power indicator
Power indicator status
Red
Illuminated
Flashing
Green
Illuminated
Illuminated
Orange
Flashing
The projector is in standby mode and image projection
is possible by pressing the POWER button.
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated red. (After a short period, a picture will be
projected.)
A picture is being projected.
The lamp is cooling down after the power is turned
off. (The cooling fan is operating.)
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated orange. (After a short period, a picture
will be projected.)
Projector status
E
-27
NGLISH
Publicité
Table des Matières
