Würth EWS 10-125 COMPACT Traduction Des Instructions De Service D'origine page 25

WARNING !
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
DANGER!
Risk of a dust explosion.
Take care to prevent the machine
¾
from drawing in additional dust and
chips.
Keep away from dust deposits when
¾
switching the machine ON and OFF.
WARNING !
Risk of severe injuries.
If the machine is set to continuous
Â
running, it will continue to run if it is
torn out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
Machines with trigger switch
Switch ON
▸
Push the trigger switch [1] forwards.
• For continuous operation, then press downwards
until it engages.
Switch OFF
▸
Press the rear end of the trigger switch [1] and
release.
Machines with dead man function
Switch ON
▸
Push the switch-on inhibitor [4] in the direction of
the arrow and press trigger switch [3].
Switch OFF
▸
Release trigger switch [3].
Working instructions
Grinding
▸
Apply moderate pressure with the machine and
move back and forth across the surface so that the
workpiece surface does not become too hot.
Roughing
▸
A good working result is obtained with a working
angle of 30° - 40°.
Cut-off grinding
Attention!
Always work up-milling mode during cut-off
¾
grinding!
Otherwise there is a risk of the machine jumping
Â
uncontrolled out of the cut.
▸
Work with moderate feed adapted to the material
being cut. Do not tilt, press or oscillate.
Sanding
▸
Apply moderate pressure with the machine and
move back and forth across the surface so that the
workpiece surface does not become too hot.
Working with wire brushes
▸
Apply moderate pressure with the machine.
Maintenance and cleaning
WARNING !
Danger of electric current.
Carry out maintenance and cleaning
¾
work on the device only when the
mains plug has been removed.
CAUTION!
Dusts from materials can be harmful to
health.
Use a dust mask or respirator.
¾
Motor cleaning
▸
Blow out the machine with compressed air through
the rear ventilation slots regularly, frequently and
thoroughly. Hold the machine firmly while blowing
out.
25