Würth EWS 10-125 COMPACT Traduction Des Instructions De Service D'origine page 23

Device elements (Fig. I/II)
1 Trigger switch for switching ON/OFF
2 Wheel for speed setting**
3 Trigger switch**
4 Switch-on inhibitor**
5 Rubber plate with abrasive sheet*
6 Cup brush*
7 Auxiliary handle/auxiliary handle with vibration
damping**
8 Two-hole wrench**
9 Two-hole nut**
10 Quick-clamping nut (Q-Nut)**
11 Abrasive wheel*
12 Cut-off safety hood clip*
13 Safety hood
14 Supporting flange
15 Spindle
16 Spindle locking knob
17 Locking lever
* Accessory, not included in the scope of delivery
** depending on the model
Start-up
Attention!
Before initial use, check that the specifications of
your mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
Attaching auxiliary handle
CAUTION!
Risk of severe injuries.
Work only with the auxiliary handle
¾
[7] attached!
▸
Screw in the auxiliary handle firmly on the left-
hand or right-hand side of the machine.
Attaching the safety hood (Fig. II)
CAUTION!
Risk of severe injuries.
For safety reasons, use only the safety
¾
hood intended for the respective
grinding wheel!
Use only attachments with a
clearance of at least 3.4 mm to
the safety hood.
Safety hood for grinding
Intended for use in work with roughing discs, multi-
disc grinding wheels, diamond cut-off wheels.
▸
Press and hold locking lever [17].
▸
Push safety hood [13] onto the spindle neck as
shown.
▸
Adjust the position of the safety hood to the posi-
tion of the hand on the machine. Turn the safety
hood until it is in the desired position.
The closed side of the safety hood must be facing
3
towards the operator.
▸
Release the locking lever and turn the safety hood
until the locking lever audibly engages.
▸
Check that the dust extraction hood is secure: The
lever must be engaged and it must not be possible
to turn the safety hood.
Cut-off safety hood clip for cut-off grinding
Intended for use with cut-off wheels, diamond cut-off
wheels.
▸
With the cut-off safety hood clip [12], the safety
hood becomes a cut-off safety hood.
Attaching grinding wheel
WARNING !
Risk of severe injuries.
Pull the mains plug out of the plug
¾
socket before all tooling operations.
The machine must be switched off
¾
and at a standstill.
Locking spindle
▸
Press in spindle locking knob [16] and turn the
spindle by hand until the spindle locking knob
audibly engages.
Fitting abrasive wheel or disc
▸
Push supporting flange [14] onto the spindle.
It is fitted correctly when it cannot be turned on
3
the spindle.
▸
Push abrasive wheel [11] onto the supporting
flange [14].
• The grinding wheel must rest uniformly on the
supporting flange.
• The sheet metal flange of cut-off wheels must rest
on the supporting flange.
23