Turntable Operation - auna Pureness Mode D'emploi

socket (14) to the auxiliary input jacks on your Hi-Fi / Amplifier system
with RCA cables.
3. You may select the Phono Thru (Phono Direct) / EQ ON (via Pre-
amplifier) button (12).
If set the Phono Thru / EQ ON selector (12) at EQ ON position, the
output signal will pass through the system's built-in pre-amplifier
circuit. If set the selector (12) at Phono Thru, the output signal will come
directly from the cartridge and without amplified.
4. Press the Power On/Standby (10) button to low position and the Power
LED Indicator (7) will be light up in red. Your system is now ready to
play your music. Please refer to the Operations section of this Manual
for details.

TURNTABLE OPERATION

• Remove the stylus protector.
• Untie the cable holding the tone arm in place, and make sure to unlock
the Tone Arm Lock (8) before operating the unit.
• It is recommended to set the Phono / Line selector (12) to Phono Thru.
• The Auto Stop On/Off switch (6) is set in "ON" position.
1. Press the Power On/Standby (10) button to low position and the Power
LED Indicator (7) will be light up in red.
2. Set the speed selector (4) to the proper position depending on the
record to be played.
3. Place the record on the platter.
4. Set the cue lever (5) to the up position and slowly move the Cartridge
Head Shell (9) to the record side. The platter will start to rotate and
position the tone arm over the desired position of the record.
5. Pull down the cueing lever (5). The tone arm will come slowly on the
recorder and start playback.
6. At the end of record, the platter will automatically stop spinning. Lift
the tone arm from the record and return it to the rest.
7. To stop manually, lift the tone arm from the record and return it to the
rest.
Remarks
• Some types of records may have an auto-stop area outside the preset
limit, so the turntable may stop before the last track finishes. In this
case, set the Auto Stop On/Off switch (6) to the "OFF" position. This
allows the record to play to the end, but please note that it will not stop
automatically. You must manually raise the tone arm and place it back in
EN
23