Installation - auna Pureness Mode D'emploi

EN
22

INSTALLATION

Precautions
1. Unpack all parts and remove protective material.
2. Do not connect the unit to the mains before checking the mains
voltage and before all other connections have been made.
3. Do not cover any vents and make sure that there is a space of several
centimeters around the unit for ventilation.
Installation of counter weight
1. Slide in the counter weight (2) completely into the rear of the tone arm
until it reaches the end. Turn it clockwise until it click with pit inside.
2. Twist the counter weightclockwise & backwarduntil it reach the
whiteinner line as below figure.
3. Twist the counter marking until it reach position "0". The pressure at the
position "0" at the white line is 3 grams.
4. Rotate the counter weight anti-clockwise and inward for a whole turn,
ie when reaching "0" again, it will increase for 1 gram. It means that
the press will reach 4 grams after turning for one turn inward, 5 grams
after turning for two turns inward.
5. To reduce the press, rotate the counter weight clockwise and backward
for a whole turn to reduce the press for 1 gram.
6. Keep rotating the counter until it reaches the appropriate working
pressure.
Remark : the working pressure of the provided stylus is from the range
4-6 grams. According to the cartridge manufacturer. All stylus has its own
working pressure and please refer to the specification respectively.
Connection
1. Insert the DC plug (16) to the DC jack (11) of the main unit, then connect
the AC/DC adaptor (15) to AC outlet.
2. Please connect your turntable unit to your Hi-Fi / Amplifier system with
speaker for music listening. It can be done by connecting the Line out