Stereo Phonograph Operation - auna TT-138 DAB Mode D'emploi

3. Press the Push Select button (12) again to confirm and the display will
show "system reset" then "ok". Then the unit will start auto scan and
return to the radio afterwards.
4. The device will erase all the programmed memory stations. Perform the
preset station again as above.

STEREO PHONOGRAPH OPERATION

Please note before use
• Remove the stylus protector.
• Make sure that the tone arm is unlocked and free to move from the tone
arm rest prior to operating. Lock the tone arm again when not in use.
1. Turn on the unit by pressing the Power On/Off button (2) and press the
Function button (8) to enter to PHONO mode.
2. Raise the turntable dust cover.
3. Place the record on the platter (use the 45 RPM record adaptor (16) if you
are playing 45 RPM records).
4. Set the speed selector (14) to the proper position for the record you are
playing.
5. Lift the tone arm from the rest (16) and slowly move it over the record.
The platter will begin spinning.
6. Place the tone arm down onto the record in the location that you want
to play.
7. Adjust the volume (6) to the desired level.
8. At the end of record, the platter will automatically stop spinning. Lift the
tone arm from the record and return it to the rest.
9. To stop playing manually, lift the tone arm from the record and return it
to the rest.
NOTE: Some types of records may have an auto-stop area outside the
preset limit, so the turntable may stop before the last track finishes. In
this case, set the AUTO-STOP switch to the "OFF" position. This allows the
record to play to the end, but please note that it will not stop automatically.
You must manually raise the tone arm and place it back in the rest and then
turn off the power to stop the turntable from spinning.
EN
23