Dab-Radio - auna TT-138 DAB Mode D'emploi

FM-Stereo reception
Follow the below procedure to select FM reception in Stereo (Auto) or
Mono:
1. In FM mode, press the Menu button (3) to enter the "Menu", then rotate
the Push Select button (12) to select "Audio setting".
2. Press the Push Select button (12) to enter the "Audio setting", then rotate
the Push Select button (12) to select "Stereo" or "Mono". Then press the
Push Select button (12) to confirm the setting.
3. In particular when stereo signals are weak, it is preferable to receive the
program in Mono.
Radio data system (RDS)
This is the feature to display the information which released from the
radio broadcast and will showed on LCD display step by step as below by
pressing the Menu/Info button (3) button continuously.
Signal strength frequency  program type  time / date  mono/stereo
 radio text.

DAB-RADIO

1. After turning on the unit, set the unit to DAB mode by pressing the
Function button (8).
2. Press the Scan (9) button once, unit will start to full scan from range
11b-12d one time within around 2 second. Then rotate the Push Select
button (12) to select your desired DAB channel.
3. Press the Info button (4) continuously to check the below info released
by DAB.
Scrolling text  time date  frequency  transfer rate  group name
 signal strength  program type .
4. Adjust the Volume Knob (6) to desired volume level.
Preset stations
You can store up to total of 40 radio stations in the memory
(20-FM/20-DAB).
1. Set to FM/DAB mode
2. Turn to the desired radio station by " manual " or " auto " tuning method.
3. Press and hold the Pre / Memory button (10) around two second to
enable memory state, the preset station will flash on LCD display.
4. Rotate the Push Select button (12) button to select the desired station
memory for storage.
5. Press Push Select button (12) to confirm the preset memory and the
EN
21