Fm Radio - auna TT-138 DAB Mode D'emploi

EN
20
Connections
1. Connect the power cord to an AC outlet.
2. Connect the provided FM Antenna to the FM Antenna Socket (18).
3. Turn on the power by pressing the Power On/Off button (2) and the LCD
display (1) will light up, your system is now ready to play your music.
Please refer to the Operations section of this Manual for details.

FM RADIO

Getting started: Connect the provided FM Antenna to the FM Antenna
Socket (18).
Manual tuning
4. Turn on the unit by pressing the Power On/Off (2) and press the Function
button (8) to enter to FM mode.
5. Tune to requested radio station by pressing the Skip up /down button
(7)
6. Adjust the Power ON-OFF/ Volume Control Knob (15) to desired volume
level.
Auto tuning
1. Set the unit to FM mode.
2. Press the Scan button (9) once, unit will start to scan at tuning up direct
until radio station received. Press and hold the Scan button (9) for a
second, the unit will scan to tuning down direction.
3. If the radio data system (RDS) broadcasting signal received, the unit will
set the actual time automatically.
4. Adjust the Power ON-OFF/ Volume Control Knob (2) to desired volume
level.
FM scan setting
After auto tuning if many unwanted weakness radio station received, you
can select strong station only to filter the weakness signal station.
1. In FM mode, Press and hold the Menu/Info button (3) to enter the
"Menu", then press Skip up / down button (12) button to select "Scan
setting".
2. Press the Push Select button (12) to enter the "Scan setting", then rotate
the Push Select button (12) to select "Strong station only". Then press the
Push Select button (12) to confirm the setting.
3. The display will automatically return to the radio station. Perform the
auto tuning operation again as above.