Changement De L'huile Du Moteur; Changement De L'huile Des Essieux Essieu Av; Changing The Engine Oil; Front Axle - ahlmann AL70 Manuel De L'opérateur

Table des Matières

Publicité

All manuals and user guides at all-guides.com
8.2.6 Changement de l'huile
du moteur
(1) Déverrouiller le capot arrière
de l'engin, le soulever vers le haut
et le fixer.
(2) Dévisser les deux vis de fixa-
tion (SW 13) de la tôle de protection
antibruit (8-8/flèche) et basculer la
tôle de protection antibruit vers
l'arrière.
(3) Placer un collecteur d'huile
suffisamment grand en dessous.
(4) Dévisser le bouchon de la vis
de vidange (8-9/flèche).
(5) Visser un flexible de la caisse
d'outillage sur la vis de vidange.
(6) Retirer
le
fermeture du flexible.
(7) Pour la suite, se référer aux
instructions de service du moteur.
8.2.7 Changement de l'huile
des essieux
Essieu AV
(1) Placer en dessous un collec-
teur suffisamment grand.
(2) Dévisser les bouchons d'obtu-
ration (8-10/1 et 8-10/2) du pont et
laisser l'huile s'écouler.
ATTENTION
Eliminer «l'huile usée» selon les
prescriptions de protection de
l'environnement!
(3) Visser le bouchon d'obturation
(8-10/2) avec un nouveau joint.
(4) Remplir d'huile par l'orifice du
bouchon d'obturation (8-10/1),
jusqu'à ce que l'huile atteigne
l'ouverture.
L06M
8.2.6 Changing the engine
oil
(1) Unlock, open and secure rear
flap of the loader.
(2) Remove both screws (SW 13)
of the noise protection sheet (8-8/
arrow) and open noise protection
sheet.
(3) Place a sufficiently large oil
drain pan underneath the sump.
(4) Unscrew cover of oil drainage
screw (8-9/arrow).
(5) Screw the drainage nozzle with
a hose (toolbox) to the oil drain.
bouchon
de
(6) Remove the cover cop from
the hose.
(7) Further procedures are to be
found in the Engine Operating
Manual.
8.2.7 Changing the axle oil

Front axle

(1) Place an oil catch pan under-
neath the axle.
(2) Unscrew the plug from the
axle arch (8-10/1 and 8-10/2) and
let the oil drain out.
Waste oil must be disposed of in
such a way that it will not cause
pollution.
(3) When replacing the axle plug
(8-10/2) use new gaskets.
(4) Re-fill the oil into the plug bore
of the axle arch (8-10/1) until the oil
reaches opening.
CAUTION
8-6

Publicité

Table des Matières
loading

Table des Matières