Eaton CROUSE-HINDS Serie Mode D'emploi page 22

12 Repairs / Overhaul / Modification
Repairs that affect the explosion protection, may only be carried
out by COOPER CROUSE-HINDS or a qualified electrician (Competent
person) in compliance with the applicable national rules
(IEC/EN 60079-19).
Warning against electric shock.
Before opening the enclosure make sure that the apparatus is
disconnected from the voltage, or take the appropriate protective
measures.
Make sure that there is no explosive ambient atmosphere when
opening the equipment.
For replacement and repair only original parts from
COOPER CROUSE HINDS-/ EATON may be used.
If it is necessary to replace the LED module, it have to be replaced
with a new LED module that is assigned to the respective ExLin NE+
luminaire type.
If the built-in qTEK driver must be replaced, have to be used the qTEK
driver assigned as standard driver for the ExLin NE+ luminaire in
question (see Technical Data).
Modifications to the device or changes of its design are not permitted.
They shall be used for their intended purpose and in perfect and clean
condition.
12.1 Dismantling / Assembly of the battery pack
The battery pack may be installed in the ExLin NE+ luminaire in zones 1
and 21 explosive atmospheres.
X
In areas with process-related dirt or dust, have to be to ensure
ATEX - IEC
that no dirt or dust gets into the luminaire when the battery pack is
installed.
Sealing surfaces must be free of dirt and dust.
12.1.1 Dismantling
see Fig. 9
12.1.2 Assembly
16
see Fig.
12.2 Replaceing LED module
25
19
see Fig.
...
22
Explosion protected emergency light fittings ExLin NE+
13 Disposal/Recycling
When the apparatus is disposed of, the respective national regulations on
waste disposal will have to be observed.
In case of disposal you can obtain additional information from your Cooper
Crouse-Hinds /EATON branch.
Subject to modifications or supplement of the product range.
GB