GE 20 Manuel D'utilisation page 26

REVERSING THE DOOR SWING
REHANG REFRIGERATOR DOOR
6
Lower the refrigerator door onto the center
A
hinge pin. Ensure that the plastic hinge pin
thimble is on the center hinge pin or inside
door hinge pin hole located in the bottom
of the door.
Insert the door thimble into the hinge hole
B
on top of the refrigerator door and then
insert the top hinge pin. Make sure the door
is aligned with the cabinet. Attach the hinge
to the top of the cabinet loosely with the bolts.
Make sure the gasket on the door is flush
C
against the cabinet and is not folded. Support
the door on the handle side and make sure the
door is straight and the gap between the doors
is even across the front. While holding the door
in place, tighten the top hinge bolts. Replace
the hinge cover.
Installation Instructions
(cont.)
26
INSTALL THE LOGO BADGE
7
Remove the adhesive backing paper
and align the pins on the back of the badge
with the holes in the door. Apply pressure to
the badge to ensure it sticks to the door.