Operation And Function Of The Domestic Hot Water Heat Pump; Operation And Display; Menu Structure - Dimplex BWP 30 HS Instructions D'installation Et D'utilisation

7 Operation and function
of the domestic hot
water heat pump

7.1 Operation and display

7.1.1 Description of the key functions
Menu key: Switches to the main menu, where detailed
settings for the heat pump can be made.
Rapid heating key: Press once to switch on the heating element
for a predetermined period (from 0.5 h to
a maximum of 4 h
Press twice to switch on the heating element
continuously
Press three times to turn the heating element off
(switches on automatically when needed)
Standby key: Switch heat pump on/off; the frost protection
function is active when the heat pump is in
standby mode
ESC key: Return to the previous menu level
OK key: Beginning and completion of a parameter
change / selection of a desired menu item;
special function in the start screen: Current
actual temperatures are displayed alternately
Up arrow key: Increase a value / select menu and parameter;
special function in the start screen: Increase
domestic hot water setpoint
Down arrow key: Decrease a value / select menu and parameter;
special function in the start screen: Decrease
domestic hot water setpoint
7.1.2 Description of displays
www.dimplex.de
All manuals and user guides at all-guides.com
7.1.3 Explanation of LEDs:
Upper left (red): On when the 2nd heat generator is active.
Upper right (red): On when the heating element is active.
- Continuous ON: Heating element is active during a set time
period
- Flashing (1s cycle): Heating element is continuously on
Lower middle (green): On when the heat pump is ready for
operation
7.1.4 Description of further symbols:
urrent setpoint for domestic hot water
Cylinder temperature sensor
Current collector temperature
Renewable sensor in the cylinder
Air intake temperature sensor
Heating element on
Domestic hot water request pending
2nd heat generator on
Compressor on
Time program (block / thermal disinfection) active
Solar gain available and solar pump on
Ventilation unit active
Control for using photovoltaic electricity
Cursor for value entry and selection
Display screen can be scrolled upwards
Display screen can be scrolled downwards

7.2 Menu structure

Parameter change: The menu is accessed by pressing the
key. In this menu, changes can be made to parameters. The
desired menu item is selected using the
are marked with the cursor symbol
accessed using the key. In this submenu, the parameter that
is to be changed can be selected (also using the arrow keys).
The value to be changed is displayed in "bold" using the
and can then be changed using the arrow keys. The entry is
completed by pressing the
7.2
and keys, which
. The submenu is
key,
key again.
EN-7