Bosch MUM59 Serie Mode D'emploi page 21

■ Press the Release button and
move the swivel arm to
position 1.
■ Check the height of the whisk and, if
required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2.
■ Hold whisk in place and tighten nut
anticlockwise using open­ended wrench
(size 8).
Working with the bowl and the
tools
Figure F:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Figure E-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Our recommendation:
– P rofessional flexi stirring whisk:
First mix at setting 1­2, then setting 3­5
as required
– P rofessional beating whisk:
setting 7, mix in at setting 1
– K neading hook:
first stir in at setting 1, knead at setting 3
All manuals and user guides at all-guides.com
Adding more ingredients
■ Switch off the appliance with the rotary
■ Add more ingredients through the feed
or
■ Remove lid.
■ Press the Release button and
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
Continuous-feed shredder
W Risk of injury!
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuous­feed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.
Warning!
The continuous­feed shredder must be
completely assembled before use. Never
assemble the continuous­feed shredder on
the base unit. Operate the continuous­feed
shredder in the indicated operating position
only.
switch.
tube in the cover.
move the swivel arm to
position 2.
switch.
move the swivel arm to
position 2.
servicing".
en
Operation
21