Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Symbol Function
•'ˆ
Wi-Fi signal strength
Not connected to home network (Wi-Fi).
‹
Signal strength 1 (poor)
‚
Signal strength 2 (moderate)
ƒ
Signal strength 3 (good)
„
•'‰
Connection to Home Connect server
Not connected.
‹
Connected.
‚
* Basic setting
Notes
The
setting is only displayed if the appliance is
•'ƒ
▯
connected to the home network.
The
setting is only displayed if the appliance has
•'„
▯
once connected to a network.
The
setting is only displayed if an update is
•'†
▯
available.
The
setting is only displayed if Customer Service
•'‡
▯
is attempting to connect to the appliance. You can end
this at any time after granting access.
The
and
settings are only displayed if there
•'ˆ
•'‰
▯
is a connection to Wi-Fi.
Deactivating Wi-Fi
If Wi-Fi has been activated, you can use the
Home Connect functions.
Note: In networked standby mode, your appliance
requires a maximum of 2 W.
Turn on the cooktop.
1.
Touch and hold the kitchen timer key for 4 seconds.
2.
The product information is displayed.
Touch the kitchen timer key repeatedly until
3.
are displayed alternately.
„
lights up in the cooking position display.
‚
Set the
value on the control panel.
‹
4.
This deactivates Wi-Fi; the
control panel.
26
•'
symbol will go out on the
D
Disconnecting from the Network
You can disconnect your cooktop from the network at
any time.
Note: If your cooktop is disconnected from the network,
it is not possible to operate it using Home Connect.
Turn on the cooktop.
1.
Touch and hold the kitchen timer key for 4 seconds.
2.
The product information is displayed.
Touch the kitchen timer key repeatedly until
3.
‚
are displayed alternately.
lights up in the cooking position display.
„
Set the
value on the control panel.
‹
4.
This disconnects the appliance from your home network;
the
symbol will go out on the control panel.
D
Connecting to the network
Turn on the cooktop.
1.
Touch and hold the kitchen timer key for 4 seconds.
2.
The product information is displayed.
and
On the control panel
3.
set the "Connect automatically"
or the "Connect manually"
Follow the instructions as per ~ "Automatic
4.
Registration in the Home Network" or ~ "Manual
Registration in the Home Network".
•'
C o n n e c t i n g t o t h e n e t w o r k
‚
value or
value.
ƒ
and
Publicité
Chapitres
Table des Matières
