SATA SATAjet 1000 A RP Mode D'emploi page 425

All manuals and user guides at all-guides.com
Notice!
Improper assembly can lead to
damage to the automatic gun.
→ Arrest automatic gun on a level
surface before performing main-
tenance work.
→ Ensure that threads are seated
properly.
→ Lubricate all moving parts
with SATA gun grease (Art. No.
48173).
Loose screws can lead to part
damage or malfunction.
→ Tighten all screws by hand and
check for tightness.
Use of the wrong tools can lead
to damage to the automatic gun.
→ Use only special tools supplied
by SATA.
Springs and small parts can fall
out during disassembly. The ex-
act installation position and instal-
lation sequence is shown in the
illustrations. Failure to observe
can lead to damage to the com-
ponents or to malfunction.
Replacement parts are available
for repair (see Chap. 13).
10.1. Replace nozzle set
The nozzle set consists of a tested
combination of paint needle
air nozzle and paint nozzle
[7-7]
. Always replace the complete
[7-6]
nozzle set.
Disassemble nozzle set
■ Unscrew regulating cap [7-1].
■ Unscrew end cap (24 mm) [7-2].
Operating Instructions for SATA Automatic Guns
■ Remove both springs [7-3], [7-4].
■ Remove paint needle [7-5].
■ Unscrew air nozzle ring [7-8] by hand
and remove together with air nozzle
[7-7].
■ Unscrew paint nozzle [7-6] using
SATA universal wrench.
Install new nozzle set
The components can be dam-
aged if installed in the wrong
sequence.
→ Always install paint nozzle
before installing paint needle.
The SATAminijet version has a
small grooved pin for aligning the
air nozzle.
■ Screw in paint nozzle [7-6] using
SATA universal wrench.
■ Install air nozzle ring [7-8] together
with air nozzle [7-7] and screw on
by hand. Pay attention to desired
nozzle position and alignment of
notches in air nozzle in relation to
grooved pin [8-1] (not on SATA-
minijet).
■ Install paint needle [7-5].
■ Install both springs [7-3], [7-4].
■ Screw on end cap [7-2].
,
[7-5]
■ Screw on regulating cap [7-1].
■ Adjust required material flow rate
(see Chap. 9.2).
Notice!
Information!
US
425