Gima ECG90A Notice D'utilisation page 74

APPENDIX
Guidance and manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environments listed below, and
should only be used in such environments:
IMMUNITY TEST
Electrostatic
discharge (ESD)
IEC 61000-4-2
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Interruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11
All manuals and user guides at all-guides.com
ENGLISH
IEC 60601
TEST LEVEL
± 6 kV contact
± 8 kV air
3 A/m
± 2 kV for power
supply lines
± 1 kV line(s)
to line(s)
± 2 kV line(s)
to earth
<5% U
T
(>95% dip in U
)
T
for 0,5 cycle
40% U
T
(60% dip in U
)
T
for 5 cycles
70% U
T
(30% dip in U
)
T
for 25 cycles
<5% U
T
(>95% dip in U
)
T
for 5 sec
COMPLIANCE ELECTROMAGNETIC
LEVEL ENVIRONMENT – GUIDANCE
± 6 kV contact Floors should be wood, con-
± 8 kV air crete or ceramic tile. If floors
are covered with synthetic
material, the relative humidity
should be at least 30%.
3 A/m Power
fields should be at levels cha-
racteristic of a typical location
in a typical commercial or ho-
spital environment.
± 2 kV for power Mains power quality should be
supply lines that of a typical commercial or
hospital environment.
± 1 kV line(s) Mains power quality should be
to line(s) that of a typical commercial or
± 2 kV line(s) hospital environment.
to earth
<5% U
Mains power quality should be
T
(>95% dip in U
that of a typical commercial or
)
T
for 0,5 cycle hospital environment.
If the user of the device requi-
40% U
res continued operation during
T
(60% dip in U
power mains interruptions, it is
)
T
recommended that
for 5 cycles
the device be powered from an
70% U
uninterruptible power supply or
T
(30% dip in U
a battery
)
T
for 25 cycles
<5% U
T
(>95% dip in U
)
T
for 5 sec
frequency magnetic
74