Gram FB Mode D'emploi page 30

GB
Power must be connected via a wall
socket with a switch. The wall socket
should be easily accessible.
All earthing requirements stipulated by the
local electricity authorities must be ob-
served. The freezer plug and wall socket
should then give the correct earthing. If in
doubt, contact your supplier or authorised
electrician.
WARNING
The flexible cord (mains lead) fitted to this
appliance has three cores for use with a
3-pin 13-Amp or 3-pin 15-Amp plug. If a
B.S. 1363 (13-Amp) fused plug is used, it
should be fitted with a 13-Amp fuse.
Important
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour markings identifying the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked "E" or an earth
symbol, or coloured GREEN, or GREEN-
AND-YELLOW. Connect the BLUE wire to
the plug terminal marked "N" or coloured
BLACK.
Connect the BROWN wire to the plug ter-
minal marked "L" or coloured RED.
Thermostat and
control panel
In addition to the thermostat button
3
there are two indicating lamps and a
switch. The green "CONTROL" lamp
lights up to indicate that the power supply
to the freezer is in order.
The red "ALARM" lamp
the temperature inside the freezer is more
30
All manuals and user guides at all-guides.com
than about –15°C. Yellow-orange "SUPER"
illuminated switch
switch): when this switch is depressed the
indicating lamp lights up and the freezer
works at its maximum level of performance
(compressor runs continuously). See also
"Freezing".
If during transport the freezer has been
laid down, or has been stored in cold sur-
roundings (colder than +5°C) it must be
allowed to stabilise for at least an hour
before being switched on.
Before the freezer is stocked, it is recom-
mended that it first be washed inside with
a mild soap in lukewarm water and then
thoroughly dried afterwards.
Start the freezer by plugging it into a wall
socket.
The green lamp
will light up to indicate that the power is on.
The red lamp
light up to indicate that the temperature in
the freezer is too high.
Now set the thermostat button
control panel. The thermostat button is
slotted and can be turned using a coin.
The thermostat button can be set between
two extreme positions, "1" and "6". The
nearer the thermostat button is turned
towards the "6" mark on the panel itself,
the lower (colder) the temperature in the
freezer will become. Conversely, if the
button is turned towards the "1" mark, the
temperature will rise (warmer).
On starting, set the thermostat button mid-
way between "1" and "6".
,
A
To get to know your freezer and the tem-
perature possibilities it offers, it is a good
B
idea to use a small thermometer.
The temperature in the freezer, measured
in the top layer of stored items, should be
C lights up when
about –18°C, the correct temperature for
storing deep-frozen produce.
D (Quick-freeze
Starting up and
temperature control
on the control panel
B
C on the control panel will
A on the
4