Maintenance And Cleaning; Cleaning The Exterior Of The Appliance; Emptying The Condensate Tank - Inventum VDW9001B Mode D'emploi

5

maintenance and cleaning

WARNING! Always unplug the appliance before cleaning and maintenance.

CLEANING THE EXTERIOR OF THE APPLIANCE

Proper maintenance on the appliance can extend its useful life.
Clean the exterior of the appliance and control panel using a soft damp
cloth and water. If necessary, a diluted non-abrasive neutral cleaning
agent can be used to clean the appliance.

EMPTYING THE CONDENSATE TANK

1. Pull out and hold the condensate tank with
two hands.
2. Tilt the condensate tank, pour out the
condensate water into the basin.
3. Install the condensate tank.
WARNING!
• Empty the condensate tank after each use. Should the condensate tank fill up completely,
the programme will be paused and the symbol
the dryer can be restarted by pressing the Start/Pause button.
• Do not drink the condensate water.
• Do not use the dryer without the condensate tank.
CLEANING THE DRYER FILTER
Open the filter
housing.
NOTE!
• The lint accumulated on the dryer filter will block the air circulation, which will result in a longer
drying time and an increased energy consumption. Therefore, the dryer filter must be cleaned
after each use.
• Do not operate the dryer without the dryer filter!
• Clean the dryer filter after each use to prevent lint accumulation
inside the dryer.
Pull out the dryer
filter.
will light up. Once the tank is emptied,
Gently scrape the
filter to remove the
lint, i.e. the lining of
fibres and threads,
with your hand or with
a cloth.
If necessary, clean
the filter housing and
door gasket as well.
Insert the dryer filter
and close the filter
housing.
51
English •