Levelling The Appliance - Inventum VDW9001B Mode D'emploi

INSTALLING THE EXTERNAL DRAINAGE HOSE (INCLUDED)
Install the external drainage hose if you do not want to use the internal condensate tank.
1. Release the hose from the
holder on the rear of the dryer
(left hand side, below the
top cover).

LEVELLING THE APPLIANCE

WARNING!
Incorrect levelling of the appliance with the adjustable
feet may cause vibration, appliance moving across the
room, and loud operation.
Use a spirit level and a spanner No. 22 to level the
appliance.
1. Rotate the adjustable feet with a spanner.
2. Level the appliance in longitudinal and traverse
direction.
CONNECTING THE APPLIANCE TO THE POWER MAINS
WARNING!
• Before connecting the appliance to the power mains, wait for at least 2 hours until room
temperature has been reached.
• Connect the appliance to an earthed power outlet. After installation, the wall socket must
be freely accessible. The socket must be fitted with an earth contact (in compliance with
the relevant regulations).
• Information about your appliance is indicated on the rating plate.
• Using an over-voltage protection to protect the appliance in case of a lightning strike,
is recommended.
• Do not connect the appliance to the power mains using an extension cord.
• Do not connect the appliance to an electrical outlet intended for an electric shaver or
hair dryer.
• Any repair and maintenance pertaining to safety or performance must be done by
trained experts.
• A damaged power cord may only be replaced by a person authorised by the manufacturer.
38
• English
2. Put the hose into a drain pipe,
wash basin or any other sink.