Hendi 281376 Mode D'emploi page 8

Programming
This microwave can preset up to 99 programs. See
and follow "User options - 9 Double digit" session
for setting program no. from 10 to 99 . Open the door
and press and hold "1" on the number keyboard for
about 4 ~ 6 seconds, the buzzer will sound and the
display will show 'PROGRAM' to indicate you en-
tered program mode. Select the time with the '
button, the display will show "00:00", select the re-
quested time with the number keyboard. After that,
select the power level. Press '
lect the power level with the number keyboard as
shown in below table (Defrost/10%/20%/30%/40%/
50%/60%/70%/80%/90%/100%). The display will
show the selected power. If you press again the
same power level button, the power will be back to
set 100% power. Also, if no power level button is set,
the power will be default to 100%. After setting the
time, power and press the 'start' button to safe the
program. The display will show 'PROGRAM'. Close
the door to return to 'ready mode'. If you want to
cancel during programming, press the 'pause' but-
ton and the oven will return to the 'door open' mode
and the program won't be saved.
EN
Below a quick guide how to make a program of 1.25
Double and triple quantity (X2 or X3)
This microwave is equipped with a function to cal-
culate the amount of time needed when preparing
a double or triple quantity of food. Press the 'X2' or
'X3' button followed by the program and the micro-
8
All manuals and user guides at all-guides.com
' first and then se-
minutes at 70% power:
1) Open the door and press number button '1' for
about 4 ~ 6 seconds, display will show 'PRO-
GRAM'.
2) Press number button '3', display shows P:03. Af-
ter 2 seconds the display will show the time relat-
' ed with the program ':30'.
3) Press the number buttons '1' '2' '5' to set the
cooking time.
4) Press ' ', and choose 7 on the number keyboard
for power level 70%. The display will show '1:25
70'.
5) Press the 'u' button. The program is now saved
under number keyboard '3'.
To overwrite the program repeat the steps above.
Note: Total programming time is limited to 60 min-
utes only.
Note: When the cooking time exceeds the maxi-
mum time the microwave can operate (standard
60 minutes) three beeps will be sound. This means
you need to adjust the time before the program can
work.
wave double or triple the time you preset and start
the process. This function can only be used in com-
bination with a preset program.