Hendi 281376 Mode D'emploi page 13

Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the microwave.
• Beware: Never immerse the microwave in water
or any other liquid!
• Clean the outside of the microwave with a damp
cloth and water with mild detergent. And dry af-
terwards.
• Clean the inside and door with a damp cloth and
water with mild detergent to remove all food and
grease build up.
• Remove any spillage right after each use. Not
cleaning can result in burnt is stains and bad
smells.
How to remove and re-install the air filter
This filter is placed before the air inlet and should be
cleaned regularly to keep the chamber clean.
1) Turn the filter screws counterclockwise to unlock
the filter and take it out. Wash the filter with luke-
warm water with a mild detergent until it's clean
as possible. Let the filter dry before re-installing
it.
2) Re-install the filter screen, place the filter screws
and turn them clockwise to lock the filter in posi-
tion
How to remove and re-install the splash shield
Warning: before removing or installing the shield,
make sure the microwave is unplugged from the
power outlet and the microwave is cool down.
1) Detaching: Hold the two buckle positions in front
of the splash shield with your hands (position in-
dicated by the arrows). Pull on the buckles in the
direction of the arrows. Once the buckles are out
gently take the splash shield down.
All manuals and user guides at all-guides.com
• Keep the sealing gaskets on the door clean, clean
them regularly with a wet cloth and water with a
mild detergent.
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects. Do
not use petrol or solvents! Clean with a damp cloth
and detergent if necessary. Do not use abrasive
materials.
• Clean the grease and air filter regularly, the micro-
wave might overheat when this isn't done properly
or food will get contaminated with grease.
3) The microwave has a function to remind users of
cleaning the filter every 30 days.
4) When the microwave display shows 'CLEAN FIL-
TER' check if the filter needs cleaning, to erase
this message from the display hold the 'pause'
button for 3 seconds.
2) Wash the splash shield with lukewarm water and
mild detergent.
3) Installation: Pick up the splash shield and lock
the pins in the holes on the rear plate of the
chamber, move the splash shield in position and
re-attach the buckles.
EN
13