Assembling The Breast Pump - Philips AVENT SCF394 Mode D'emploi

Battery indicator light description
All lights are steady
on. The battery is
fully charged.
Charged battery
operates
approximately
3 pumping
* One session is the equivalent of 15 minutes (double electric breast pump) or 30 minutes (single electric
breast pump).

Assembling the breast pump

Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch
breast pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the breast
pump to form a proper vacuum.
1. Wash your hands
thoroughly with soap
and water.
Two lights are First light flashes
steady on. slowly.
The battery is The battery is
charged sufficiently charged sufficiently
for maximum two for maximum one
sessions.* session.*
2. Push the white valve in
the pump body as far as
possible.
First light flashes
quickly.
The battery is very
low, the device
will soon stop
operating, charging
is needed.
3. Screw the pump body
onto the bottle.
English
Battery lights light
up one by one and
go out all together.
The battery is
charging.
4. Place the cushion in
the pump body and
make sure that the rim
covers the pump body.
13