Function 5 - Reset Network Parameters To Zero - Honeywell 301W Manuel De L'utilisateur

All manuals and user guides at all-guides.com

Function 5 - Reset Network Parameters to Zero

This function, which should only be used by authorized, fully
qualified technicians, resets the transmitter's network parameters to
zero, enabling the transmitter to look for a new controller in Association
mode (see 301C manual for details).
• Press pushbutton 1
• Press pushbutton 2, count 6 blinks and release.
• Press pushbutton 1.
This function resets the transmitter; once reset, transmitters
may change IDs, and thus render controller Events and
Groups inoperable.
Function 6 - Activate a Check Test
This test essentially sends a neutral command that causes the
transmitter to react, thus enabling you to tell whether it is still
functioning.
• Press pushbutton 1
• Press pushbutton 2, count 7 blinks and release.
• Press pushbutton 1.
Once this function has been executed, the LEDs will display the result:
Success: Both LEDs blink simultaneously 6 times, for three cycles.
Failure: LED 1 blinks 6 times, for 3 cycles while LED 2 blinks non-
stop throughout the cycles.
511398
5/07
How to Program the Transmitter
301W User Manual
Honeywell
Using the Transmitter
25