Symbols That Appear On This Manual; General Instructions - Nilfisk 9084310010 Instructions D'utilisation

ENGLISH

SYMBOLS THAT APPEAR ON THIS MANUAL

DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the Instructions for use Manual before performing any procedure.

GENERAL INSTRUCTIONS

Specific warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
– Before performing any maintenance, repair, cleaning or replacement procedure disconnect the battery
connector, remove the ignition key and engage the parking brake.
– This machine must be used by properly trained operators only.
– Sharp turns must be made at slowest possible speed. Avoid abrupt turns on incline.
– Do not wear jewels when working near electrical components.
– Keep the batteries away from sparks, flames and incandescent material. During the normal operation
explosive gases are released.
–
Do not work under the lifted machine without supporting it with safety stands.
–
When working under the open hood, ensure that it cannot be closed by accident.
–
Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids or
vapours: This machine is not suitable for collecting dangerous powders.
–
If the machine is equipped with lead (WET) batteries, battery charging produces highly explosive hydrogen
gas. Keep the hood open when charging the batteries and perform this procedure in well-ventilated areas
and away from naked flames.
– When lead batteries (WET) are installed, do not tilt the machine for more than 30° from the horizontal plane
to prevent the highly corrosive acid from leaking out of the batteries. When the machine is to be tilted to
perform maintenance procedures, remove the batteries.
WARNING!
–
Carefully read all the instructions before performing any maintenance/repair procedure.
–
For machines equipped with onboard electronic battery charger:
• Before using the battery charger, ensure that frequency and voltage values, indicated on the machine
serial number plate, match the electrical mains voltage.
• Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
• Keep the battery charger cable away from heated surfaces.
• Do not charge the batteries if the battery charger cable or the plug are damaged. If the battery charger
cable is damaged, contact Nilfisk Service Center.
• To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is
plugged in. Before performing any maintenance procedure, disconnect the battery charger cable from the
electrical mains.
4
INSTRUCTIONS FOR USE
SR 1101 B - 1464015000
revised 03/2018
04/2009