Bartscher 200272 Mode D'emploi page 35

•
Only move the device by lifting it, to avoid damage to the adjustable legs and other
equipment.
•
Level the device by turning its legs.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
If the device has been transported in an upright position, wait 2 hours prior to
connecting the device (integrated condenser) to a power source.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 33 -