Kohler K-704310 Mode D'emploi page 16

The top track is not shown. The wiper seals should
extend beyond the top of the glass so steam does not
come through the top of the door.
Bubble Seal
12. Install Seals and Apply Sealant
NOTE: Thoroughly clean all dust, dirt, or grease from the bottom track and shower ledge surfaces where
sealant will be applied. Make sure the surfaces are dry.
Install the wiper seal on the inside edge of the inside glass panel. This seals the gap between the
glass panels.
Install the longer bubble seals at the edge of each glass panel closest to the wall.
Apply sealant to all outside edges where the door meets the shower module.
1015440-2-E
Wiper Seal
Bubble seal will
overhang edge.
Apply silicone sealant to all door framing to shower
module contact points around the entire door frame.
16 Kohler Co.