Kohler K-704310 Mode D'emploi page 15

Install the Door Panel (cont.)
Check the motion of the panel over the length of the curb to ensure it does not bind. If readjustment
is required, do so at this time.
Repeat installation procedures with the outside panel. The bottom of the panel should be positioned
on the outside of the curb. Install the outside panel with the rollers inserted onto the track nearest
to the outside of the enclosure.
Panel Alignment
Slide the inner glass panel toward the showerhead end of the bath/shower enclosure.
NOTE: The edge of the glass panel should touch the bumpers. If the glass panel does not touch the
bumpers, the wall is not plumb and it will need to be adjusted.
Check to be certain that the glass panel is plumb with the wall.
To adjust, remove the glass panel and move one or both rollers into the other holes.
Reinstall the glass panel and recheck for plumb.
Kohler Co. 15 1015440-2-E