Kohler K-704310 Mode D'emploi page 12

Support Back
Support
Towel Bar
9. Install the Hanging Brackets and Short Bubble Seals
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set unframed tempered glass directly on the floor.
IMPORTANT! When installing the Inside Panel Rollers the rollers should be installed on the opposite
side as the "non-coated side" label.
IMPORTANT! When installing the Outside Panel Rollers the rollers should be installed on the same side
as the "non-coated side" label.
Insert one roller through the center hole on each bracket.
Secure with a screw.
Insert a bushing through each of the holes in the glass panels.
Slide two hanging brackets onto each glass panel and align the holes.
Secure the bracket to the glass with the bolts and nuts provided.
Install the short bubble seals between the hanger brackets of each panel.
10. Install the Towel Bars
NOTE: The towel bars should be installed to the same side of the glass as the rollers.
Thread the supports to the ends of the towel bar until snug. Do not overtighten.
Insert the support back through the hole in the glass and thread onto the towel bar.
Tighten the support backs so they are snug with the glass. Do not overtighten.
1015440-2-E
Bubble Seal
Roller
Blind Nut
12
Screw
Bolt
Hanging Bracket
Bushing
Kohler Co.