Kohler K-704310 Mode D'emploi page 10

Wall
Jamb
Bottom Track
6. Install the Bottom Track
NOTE: Be sure that the bath/shower threshold is clean and free of debris.
Carefully slip the bottom track assembly behind the wall jambs and onto the bath unit.
Align the holes in the clean-outs with the bottom holes of the wall jambs.
Secure the bottom track in place with the two remaining #8-18 x 1-1/2" panhead screws.
Snap the connectors into place. There should be one connector from both the top and bottom track
channels on each end of the bottom track.
Install the screw caps on all six screws.
7. Install the Top Track
Slide the top track over the tops of both wall jambs. Top track should fit snug between walls and
over wall jambs.
1015440-2-E
Clean-Out
#8-18 x 1-1/2"
Panhead Screw
Screw Cap
Slide top track
over wall jambs.
Wall Jamb
Position
connectors.
Bottom Track
10
Top Track
Kohler Co.