Maintenance Cleaning; What Should I Do If - Atag OX20A Serie Mode D'emploi

maintenance
cleaning
Use the enamelled baking tray as a drip-tray when grilling.
cleaning after use
For cleaning both the inside and the outside of the oven, it is
best to use a mild cleaning agent (washing-up liquid) and a
damp cloth. Dry with kitchen paper or a dry cloth.
Never use abrasive agents. These may harm the enamel or
cause scratches.
stubborn stains
You can remove stubborn stains with a liquid abrasive or oven
cleaner. Remove burnt-on food inside the oven with a glass
scraper.
The glass panel on the inside of the door is removable. If the
oven has been built in under the worktop, it may be that the
glass panel cannot be taken out of the door. You can clean
the window on the inside by sliding a cloth between the two
panes. The glass panel's guides on the inside of the oven
door may become discoloured if they come into contact with
oven cleaner. Read the directions on the packaging of the
oven cleaner before use.
cleaning accessories
Use a mild cleaning agent. Dry the accessory well with a dry
cloth. Any burnt-on food on the grill set can be removed
using steel wool.
grill reflector plate
The oven is equipped with a removable grill reflector plate.
When you want to clean the plate, you must pull it straight
towards you out of the oven.
When putting the grill reflector plate back, take care that the
two studs slot into the element.
GB 12
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault cause
Oven or grill does not heat up. Fuse in the meter cupboard
defective.
Temperature is not correct. Temperature set incorrectly.
Thermostat defective.
Oven light not on. No power supply.
Bulb defective.
faults

what should I do if...

solution
Replace the fuse.
Set the oven temperature
again.
Switch oven off and phone the
service department.
Insert the plug in the socket.
Switch on the two-way and off
switch in the meter cupboard.
Switch oven off and replace the
bulb. Disconnect the appliance
from the power supply by
removing the plug from the
socket or by turning the two-
way and off switch in the meter
cupboard or by removing the
fuse. You can snap the glass
cover out of the side wall of the
oven. The bulb is then
accessible. Replace it with a
new bulb 230 V-50 Hz-
300 °C/25 W.
GB 13