Items Supplied; Proper Use; Technical Data - EINHELL BT-PS 600 Mode D'emploi

Anleitung BT-PS 600_SPK1:_
Environmental protection
Please remember that packaging, old batteries and
defective storage batteries do not belong in your
household refuse. Dispose of these items through
the proper channels.

2. Items supplied

1 energy station with compressor
1 power supply unit for charging
1 connecting cable with cigarette lighter plug
1 valve adapter set

3. Proper use

The equipment is suitable for the jump starting of 12 V
starter batteries (lead acid batteries) with too little
battery capacity and for the direct or indirect
connection of 12 V consumers with max. 10A power
consumption to the cigarette lighter socket. Be sure to
observe the operating instructions of the equipment
which you connect to the energy station. With the
integrated 12 V car compressor you can inflate car,
motorcycle and bicycle tires as well as sports balls,
small water balls, small air mattresses and other
similar items.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
27.03.2008 9:00 Uhr Seite 11

4. Technical data

Storage battery:
Output voltages /
max. current consumption:
Mains voltage:
Output from power supply unit:
Nominal voltage:
Nominal current:
Nominal power:
Lamp
Compressor
5. Charging the energy station
(Important! Move the ON/OFF switch (Fig.
1/Item 1) to „OFF".)
5.1 Charging the energy station with the power
supply unit
1. Plug the connecting cable of the supplied power
supply unit in the charging socket „RECHARGE"
(Figure 1 / Item 2) on the unit.
2. Plug the power supply unit into a mains socket
outlet for 230 V ~ 50 Hz. The red LED indicator
(Fig. 1/Item 3) flashes.
3. It takes around 24 hours to charge the energy
station.
Pressing the pushbutton (Fig. 1/Item 4) displays the
charge state of the built-in battery on the integrated
voltage meter (Fig. 1/Item 5).
5.2 Charging the energy station with the
automobile adapter cable
The energy station can be charged through the
automobileʼs cigarette lighter socket.
IMPORTANT: The energy station battery has a
12 volt charge capacity. You should only charge the
energy station when en route, as otherwise the unit
will run down the vehicleʼs battery.
Never start the vehicle as long as the automobile
adapter cable is connected to the cigarette lighter
socket.
GB
12 V
12 V / 10 A via 1 cigarette
lighter socket
230 V ~ 50 Hz
12 V
500 mA
6 VA
12 V / 3 W
12 V/18 bar
11