Hitachi NP 50A Manuel D'instructions Et De Sécurité page 9

NAIL SELECTION
● Be sure to use only the genuine HITACHI
nails for the NP50A. The use of any other
nails can result in tool malfunction and/or
nail breakdown, leading to serious injuries.
Only nails shown in the Table below can be driven with
this Nailer.
23 Gauge pin nails
Min.
.024"
(0.6 mm)
ACCESSORIES
● Accessories other than those shown below
can lead to malfunction and resulting
injuries.
STANDARD ACCESSORIES
1
2
WARNING
Max.
.024"
(0.6 mm)
WARNING
4
3
1 Eye protection
2 Allen wrench for M4 screw
3 Nose cap (A)
4 Case
5 Lubricant oiler
OPTIONAL ACCESSORIES ... sold separately
○ Pneumatic tool lubricant
1 oz. (30 cc) oil feeder (Code No. 877153)
4 oz. (120 cc) oil feeder (Code No. 874042)
1 quart (1 ltr) can (Code No. 876212)
NOTE
Accessories are subject to change without any
obligation on the part of HITACHI.
APPLICATIONS
○ Installation of decorated plywood such as baseboards
and edgings in interiors of buildings.
BEFORE OPERATION
Read section titled "SAFETY" (pages 3 – 7).
Make sure of the followings before operation.
WORKING ENVIRONMENT
● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
AIR SUPPLY
● Never connect Nailer to pressure which
potentially exceeds 200 psi (13.7 bar 14
5
kgf/cm ) if a regulator fails.
2
● Never use non relieving coupler on Nailer.
English
1
1
2
1
1
WARNING
DANGER
● NEVER use reactive
gases or
bottled gases.
Explosion may occur.
WARNING
other
9