Operation; Tailstock Adjustment; Tool Rest Adjustment; On-Off-Switch - HOLZMANN MASCHINEN D 460FXL Mode D'emploi

13.2

Operation

13.2.1 Tailstock adjustment

 Move the tailstock (5) by loosening the lock lever (1) and
pushing the tailstock to the desired position on the bed. Lock
by tightening the lock lever (1).
 The spindle can extend up to 2 1/2" from the tailstock housing.
You can move the tailstock spindle (4) by loosening the spindle
lock lever (2) and then turning the hand wheel (3). Turning the
hand wheel clockwise extends the spindle; turning it
counterclockwise retracts the spindle. Lock the lock levers (1)
and the spindle lock levers (2) before operating the lathe.
 The tailstock spindle is hollow and can be accessed from the handwheel end. Use the push-out
rod to remove the center cup or to drill holes through the center of a workpiece on a faceplate.

13.2.2 Tool rest adjustment

 To move the tool rest base (1), loosen the lock lever (4) and
move the base to the right or left and back or front. Tighten
the lever (4) when the tool rest base is in the desired position.
 To adjust the angle of the tool rest (2), loosen the lock lever
(3), move the tool rest to the desired position, and tighten the
lock lever.
 To change to the other tool rest, loosen the lock lever (3) and
pull the tool rest (2) out of the tool rest base, insert the other
tool rest, adjust to desired position, and tighten the lock lever
(3).
 The tool rest should be selected as close as possible to the workpiece!
 Height adjustment just below the centerline of the workpiece.
 Rotate the workpiece by hand and check that the workpiece can rotate freely before turning!

13.2.3 On-Off-switch

Switch on: Push the green button ("I") for 2 seconds. The machine begins to run.
Switch off: Push the red button ("0").
The machine does not stop immediately! Stay as long at the machine, until the workpiece is
completely stopped (Do not stop the workpiece by hand!)
13.3

Speed adjustment

HOLZMANN MASCHINEN GmbH
N O T I C E
By changing the belt in the headstock (machine
disconnect from power supply!) are three speed
ranges settings for D 460FXL.
In this speed ranges the speed is
infinitely variable with
the speed controller (9)
after switch on (5a).
www.holzmann-maschinen.at
OPERATION
26
D 460FXL