Security Instructions; Remaining Risk Factors - HOLZMANN MASCHINEN D 460FXL Mode D'emploi

11.2

Security instructions

Missing or non-readable security stickers have to be replaced immediately!
The locally applicable laws and regulations may specify the minimum age of the
operator and limit the use of this machine!
To avoid malfunction, machine defects and injuries, read the following security instructions
•
Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid slippery
floor.
• Make sure the work area is lighted sufficiently
• Install the machine so that there is sufficient space for safe operation and workpiece handling
• Do not overload the machine
• Provide good stability and keep balance all times
• Avoid abnormal working postures! Make sure you stand squarely and keep balance at all
times.
• Always stay focused when working. Reduce distortion sources in your working environment.
The operation of the machine when being tired, as well as under the influence of alcohol,
drugs or concentration influencing medicaments is forbidden.
• Do not climb onto the machine!
• The machine must be operated only by trained persons (knowledge and understanding of this
manual), which have no limitations of motor skills compared with conventional workers..
• Do not allow other people, particularly children, to touch the machine or the cable. Keep them
away from your work area.
• Make your workshop childproof.
• Make sure there is nobody present in the dangerous area. The minimum safety distance is 2m
• Wear suitable work clothes! Do not wear loose clothing or jewelry as they might get caught in
moving parts and cause severe accidents! Wear a hair net if you have long hair.
• Loose objects can become entangled and cause serious injuries!
• Use personal safety equipment: ear protectors and safety goggles when working with the
machine.
• Do not wear safety gloves!
• Never leave the machine running unattended! Before leaving the working area switch the
machine off and wait until the machine stops.
• Always disconnect the machine prior to any actions performed at the machine.
• Avoid unintentional starting
• Do not use the machine with damaged switch
• The plug of an electrical tool must strictly correspond to the socket. Do not use any adapters
together with earthed electric tools
• Each time you work with an electrically operated machine, caution is advised! There is a risk of
electric shock, fire, cutting injury;
• Protect the machine from dampness (causing a short circuit)
• Use power tools and machines never in the vicinity of flammable liquids and gases (danger of
explosion)
• Check the cable regularly for damage
• Do not use the cable to carry the machine or to fix the work piece
• Protect the cable from heat, oil and sharp edges
• Avoid body contact with earthed
• Before starting the machine remove any adjusting wrenches and screwdrivers
• Fix the workpiece with the right tool
• Machine only stock which is chucked securely on the machine, always check before switching
the machine on
• Provide workpiece with centre holes before clamping between centres
• Before start working remove any nails and other foreign bodies from the workpiece
• Keep any machine that is not being used out of reach of children
• Never grab into the running machine!
• Remove chips and workpiece parts only if the machine is standing still!
• Never stop workpieces with the hand during run out!
• Never take measurements on a rotating workpiece!
11.3

Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest
attention is required. A safe working depends on you!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
SAFETY
22
D 460FXL