HOLZMANN MASCHINEN D 460FXL Mode D'emploi page 29

bearing seat
Remove drive shaft in bearing seat and watch
belt and pulse disc against falling
Pat drive shaft from the left with mallet gently
on the bearing seat
WARNING: Pulse disk should be rotated in
reading unit without noise !
If it does change the seat of the shim. Left /
Right on the pulse disc
Tighten Allen screws after tightening the
wheel (left hand thread)
Screw Allen screw at pulley
feeling in the longitudinal groove
of the shaft!
HOLZMANN MASCHINEN GmbH
with
www.holzmann-maschinen.at
Pulse disc carefully
Circlip only as shim!
Pulse disc speed
Insert shim on the right side, impulse disc and
new belt pulley and simultaneously
insert the drive shaft
Put distance sleeve and screw on handwheel
ATTENTION:
1. Push down engine
2. Tighten Allen screw
MAINTENANCE
place in reader !
carefully
Lefthand thread !!
2.
1.
D 460FXL
29