Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14
OPERATION
14.1
Checking Scope of Delivery
Always note visible transport damage on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
14.2
Installation site
NOTE: The floor or worktable at the installation site must be able to bear the load of the machine.
The minimum space required for the machine is determined by the dimensions of the machine
plus a safety area around the machine. Select a flat, solid surface with appropriate space for
installation. When setting up the machine, also take into account the working area required to
process workpieces. The base of this unit has mounting holes that allow it to be attached to a
workbench/machine stand (e.g.: Holzmann DSMMS1) to prevent it from moving during operation
and causing accidental injury or damage.
(DSMMS1)
14.3
Operation
Avoid touching the polishing wheel and the workpiece immediately after use as they
become very hot.
14.3.1 Operation notes
After switching on, let the polishing wheels accelerate to full speed before starting polishing.
Do not overload the machine! An unmistakable sign of overload is when the polishing wheel loses
a significant amount of rotational speed.
Wear protective goggles when polishing.
The fixing screws and flange must be checked before each use, if necessary the fixing screw must
be retightened.
14.3.2 Starting / stopping the machine
14.3.3 Polishing
With the polishing wheels different metal alloys like stainless steel, steel, aluminium, brass etc.
can be polished.
HOLZMANN MASCHINEN GmbH
CAUTION
You can switch the machine on and off with the on/off switch
Turn it on: Press button (1)
Turn it off: Press button (2)
www.holzmann-maschinen.at
OPERATION
18
DSM150PS, DSM200PS
Publicité
Table des Matières
