Storage; Disposal; Troubleshooting - HOLZMANN MASCHINEN DSM150PS Manuel D'utilisation


Fix the polishing disc and unscrew the fixing nut and flange.

Remove the old polishing disc and put on the new one.

Screw on with flange and fixing nut.

Run the polishing discs briefly in test mode and check for any irregularities such as
unbalance etc.
15.3

Storage

Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended environmental
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine on the other hand.
15.4

Disposal

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
16

TROUBLESHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up may result in serious injury or death. Before carrying out any troubleshooting
work, always disconnect the machine from the power supply and secure it against
unintentional recommissioning!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to solve the problem.
Fault
Machine cannot be switched
on
HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
Possible Cause
 Mains plug is not plugged in
 O
-O -switch is defective
N FF
www.holzmann-maschinen.at
TROUBLESHOOTING
conditions!
Remedy

Plug in the mains plug

Contact the Customer Service
Center
DSM150PS, DSM200PS
20