Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance; Maintenance And Servicing Plan - HOLZMANN MASCHINEN DSM150PS Manuel D'utilisation

Wood or plastics can also be polished.
The different processes are distinguished between pre-polishing, polishing and high-gloss
polishing.
15

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. For this reason, always disconnect the machine
from the power supply before cleaning, servicing or maintenance work and secure it
against accidental start-up!
15.1

Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Keep the surfaces and ventilation slots of the machine free of dust and dirt. For cleaning, use a
soft cloth and a mild soap solution and, if necessary, a damp-free jet of compressed air.
15.2

Maintenance

The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!

Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.

Only use perfect and suitable tools.

Only use original spare parts recommended by the manufacturer.

15.2.1 Maintenance and Servicing Plan

The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when using the machine within the specified limits:
Interval
Before every start of work
Each time after completion
of work
As required

15.2.2 Replacing the Polishing discs

Before opening the cover, make sure that the machine is disconnected from the
power supply and secured against accidental start-up. If you have just used the
machine, wait a few minutes before opening it until the grinding wheel and machine
have cooled down.
HOLZMANN MASCHINEN GmbH
WARNING
NOTICE
Component
Polishing disc
power cord
surfaces
polishing discl
WARNING
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
What to do?
check for damage
remove dust and dirt
replace
19
DSM150PS, DSM200PS