Kohler K-1714 Guide D'installation page 5

Provide clearance from wall.
2. Determine the Location of the Steam Hardware
WARNING: Risk of scalding. Do not block the steam head or locate it near a seat or bench, as the
steam head is hot during operation and may scald the user if touched.
For Custom Shower Applications
NOTE: All dimensions should be taken from the inside of the shower.
IMPORTANT! Do not install the steam control directly above or in-line with the steam heads.
It is recommended to locate the steam heads and the steam control on the same wall as the
plumbing controls.
Locate the steam heads 6" (15.2 cm) above the shower floor and 4 1/2" (11.4 cm) from the threshold.
Locate the steam control 60" (152.4 cm) above the floor of the shower, but not directly in-line with
the steam heads. Refer to the Steam Control Kit Installation Instructions for more dimensional and
installation information.
Make sure there is adequate clearance between the steam lines and any surrounding surfaces.
Kohler Co.
1" (2.5 cm) Min
10" (25.4 cm) Min
2-1/2" (6.4 cm)
6" (15.2 cm) from Floor
5
Wall Stud
1059059-2-E