User-Admissible Maintenance Operations; Remote Control Support Installation - Nice MhouseKit WU200S Instructions Et Avertissements Pour L'installation Et L'utilisation

it 180°, in either one of the two directions (fig. 47);
02. The door will lock at the first manoeuvre sent from the control
unit.
47
180°
11.4 – User-admissible maintenance operations
Listed below are the operations that the user must perform peri-
odically.
• Use a slightly damp cloth (not wet) for cleaning the sur-
faces of the devices. Never use substances containing
alcohol, benzene, diluents or other flammable substances.
Use of these substances may damage to the devices and
cause fires or electric shocks.
• Remove power to the automation before removing leaves
and stones, to ensure that noone can operate the door.
• Check the system periodically, in particular all cables,
springs and supports to detect possible imbalance, signs
of wear or damage. Do not use the automation if repairs or
adjustments are required; any fault or an incorrectly bal-
anced door may lead to physical injury.
34 – English
11.5 – Remote control battery replacement (fig. 48)
When the battery is discharged, the transmitter capacity is sig-
nificantly reduced. If, when a button is pressed, the led L1 turns
on and immediately fades to off, it means that the battery is com-
pletely discharged and should be immediately replaced.
If, on the other hand, the led L1 turns on only for a moment,
it means that the battery is partially discharged; it is necessary
to hold the button down for at least half a second because the
transmitter can attempt to send the command. However, if the
battery level is too low to complete the command (and possibly
wait for the response), the transmitter will turn off, with the led L1
that fades. In these cases, to restore normal transmitter opera-
tion, the battery must be replaced with a version of the same
type, noting the polarity as specified.
48
Batteries contain polluting substances: do not dispose
of them together with other waste but use the methods
established by local regulations.
11.6 – Remote control support installation
To install the remote control support see fig. 49.
49